|Rated Voltage:||DC24V||Housing Thickness:||2.0mm|
|Running Speed:||0.6s-8s/ 0.9s~8s||Name:||Toll Barrier Gate|
|Driven Type:||Servo Motor||Product Details:||OEM 0.6S High Speed LED DC 24V Servo Motor Toll Barrier Gate With 2.5m Round Arm|
LED Toll Barrier Gate,
DC 24V Toll Barrier Gate,
2.5m Vehicle Barrier Gate
1. Open and close speed adjustable(0.6s to 6s, 0.9s to 6s)
2. Arm direction Left and Right can change easily
3. When power off, manual open and close arm, and lock itself.
4. Wireless remote
5. Photocell I0 port output
6. Loop detector anti-collision I0 output
7. Open and close control input
8. 12V traffic light output
Toll Barrier Gate Technical Parameter
|power supply||24VDC, 100/240VAC, 50/60Hz|
|Open/close speed||0.6sec to 8sec (adjustable), 0.9s to 8sec|
|Driving method||Servo motor|
Disassemble step as below: put arm on vertical position
1. Unscrew the M8*140MM screw with a hexagonal spanner
2. Calibrate gate arm position
To calibrate the position of the barrier arm (for example, after applying excessive force), follow the steps below:
1. Open the door of the barrier box and remove the cover.
2. Loosen the two fastening screws of DZ-1 on the pendulum shaft with an M12 Allen key, so that the barrier arm
can be repositioned by hand.
3. Calibrate the position of the barrier arm (horizontal position, as shown in Figure 1).
4. Retighten the two fastening screws with a hex wrench
1. The internal wiring of the machine has been completed when it leaves the factory, please do not change it,
just connect the 220V power supply and the protective ground wire to work.
2. Traffic light interface: 2A12V voltage traffic light use.
3. Infrared anti-smashing interface: external infrared anti-radiation device, just connect the switch signal of the
4. Ground sense interface: support external ground sense. When using an external ground sensor, you only
need to connect the switch signal output by the ground sensor.
|MENU NO.||Parameter scale||Parameter name||Default||Unit||Remark|
|H00-00||10-100||Maximum speed of open arm||25||Percentage; the default maximum speed of the motor is 2000RPM|
|H00-01||10-100||Maximum speed of close arm||25||Percentage; the default maximum speed of the motor is 2000RPM|
|H00-02||5-40||Minimum speed of close arm||5||Percentage; the default maximum speed of the motor is 2000RPM|
|H00-03||5-40||Minimum speed of close arm||5||Percentage; the default maximum speed of the motor is 2000RPM|
|H00-04||50-420||Close arm deceleration angle||20.0||The smaller the parameter, the faster the speed; 50 means 5.0 degrees|
|H00-05||50-420||Close arm deceleration angle||35.0||The smaller the parameter, the faster the speed; 50 means 5.0 degrees|
Contact Person: Keira
Tel: +86 185 0748 1610