Traffic OEM Color Drop Arm Barrier Steel Sheet Housing Alluminmum Alloy

Technical Data:

Maintenance

1)Keep the barrier gate clean.

2)Check the joints every month in case of any loose parts.

3)Check the spring elasticity after barrier gate running 30,000times

4)Check the easily worn-out parts(like spring,limit switch)every half year and renew it.

5)Remote control distance will be shortened or not work in cases like big object screening, battery run out.extreme weathers.

Warranty:

1. Drive Motor is warranted against manufacturer’s defect for lifetime
2. Standard warranty for all components is valid for12 months from the date of delivery
3. This warranty does not include damages caused by:
a. Wear and Tear
b. Theft
c. Accidents
d. Act of God & Natural Disaster
e. Unstable power supply (i.e. inconsistent voltage or lightning)

• the spring is too tight, you need release the spring a little, then test it again.
• see whether the main crank touch the triangle tightly or not, if tightly, adjust it.
• reset the balance position and the electrical limit switch.

2. Why does the controller panel operate with "Di Di Di" abnormal noises?

• As for this, it means the resistance on controller board is broken, if you have professional tools to check,
• then replace that broken resistance, if not, replace that controller panel.

3. Why does the barrier finish half operation of opening and closing?

• If uses our controller panel, you only need to find resistance R37 on controller panel, and repalce it is ok.

4. When barrier closed, why is there a 5 degree angle of inclination?

• the model is not good, and the gear doesn't fit each other tightly.
• the barrier didn't adjust well, need to reset.

 
5. When barrier finish open, but it closes itself without any order control, what's the problem?

• To check the loop cable first, because the loop cable maybe brokem
• To check the motor sensor, if it is not set well, then reset it in the middle between two holes on sensor rod.

6. Why does the arm wave a lot when opening and closing?

• The spring is very tight
• The Screw touches the rubber absorption tightly, need to reset again.

7. Rubber linning installation suggestion:

• It is good use for fast speed, like 0.6s, 1s, 1.8s and 3s.
• The place with many vehicles come and go, like shopping center, carpark area.

8. Can you accept OEM/ODM order?

• Absolutely, we are manufacturer of barrier gate, with 7 years researching and developing experience.