|
Product Details:
|
| Advantages: | Arm Swing Out, Arm Auto Reverse, Speed Adjustable, Hall Limit, Backup Battery Supported | Max Arm Length: | 6m |
|---|---|---|---|
| Product Name: | Hall Limit Automatic Boom Barrier DC Motor Brushless Speed Adjustable Arm Auto Reverse | Rated Power: | 140W |
| Running Speed: | 1.5s-8s | Rated Voltage: | DC24V |
| High Light: | boom barrier gate,electric boom barrier |
||
Hall Limit Automatic Boom Barrier DC Motor Brushless Speed Adjustable Arm Auto Reverse
Features
1 The running speed can be adjusted from 1.5s to 8s
3 Open the barrier gate by motor wheel when power off ,automatically reset after power on
4 Curved crank arm three- link movement structure, the operation is stable
5 Wireless remote control control open/close
6 Auto reverse function(force adjustable)
7 Infrared photocells connector is available
8 Loop detector connector is available.
9 Well-integrated with car parking system equipment,with wire control(must be switch signal)
10 Connector for traffic light(AC220V,power less than 40W)
11 Offering dry contact signal for car parking system(COM,NC,NO)
12 Auto-delay when closing(adjustable)
13 RS485 or CAN network communication interface(no need to install module)
14 Counting interface
15 24V backup battery interface(Can be charged by using solar energy)
Technical parameters
1 Working temperature(motor): -35℃~+85℃
2 Rated voltage:DC24V
3 Running speed:1.5s-8s
4 Rated current:8.58A
5 Rated power:140W
6 No-load speed:1850rpm
7 Rated speed:1400rpm
8 Output Power:56.8N.m
9 Relative humidity:≤90%
10 Remote control distance:≤100M(in the open place)
11 IP Degree:IP44
12 Max length of arm:6M
Installation, commissioning and use
7.1 Equipment installation
7.1.1 Please select the correct type of barrier gate according to the specifications of
the pace,and then fix the barrier cabinet with expansion bolts(refer to Figure 3).
After determined the position,the barrier gate foundation should be done according to the site conditions,and
also make the cast-in-place basement for the non-concrete ground.
7.4 Adjust the Position of Barrier Arm
To adjust the position of the arm (for example, after exerting excessive force), please take the steps as below:
The parameter for selecting the balance tension spring
| Arm Type | The Length of arm | Selection Spring | |
|
Type
|
Spec.(diameter*Length) | ||
| Straight Arm/Folding Arm | 6M≥L＞5M | Extension Spring | (ø5.5x280)+(ø4.5x280) |
| 5M≥L≥4.5M | (ø5.5x280) | ||
| 4.5M＞L≥3M | (ø4.5x280) | ||
| Fence Arm | 5M≥L≥4M | (ø6.5x280)+(ø6.5x280) | |
| 4M＞L≥3M | (ø5.5x280)+(ø4.5x280) | ||
(the parameter is based on the company’s arm)
Wonsun is a professional manufaturer for barrier gate, boom barrier, sliding gate motor. If any interest, please contact me freely.
Contact Person: Keira
Tel: +86 185 0748 1610
Fax: 86-0755-84536531
