|Product Name:||Parking Lot Automatic Boom Barrier System Gate And Gate Arm Barrier||Machine Case:||Varnished 2.0mm Steel Plate|
|Working Environment Temperature:||-40 ℃ ~ +85 ℃||Operation Time:||0.3,0.6,0.9,2,4sec|
|Power Supply:||Power Supply||Warranty:||Liftetime Warranty For Motor, 2 Years Warranty For The Rest Parts Except Arm And Remote|
boom barrier gate,
security boom gate
Parking Lot Automatic Boom Barrier System Gate And Gate Arm Barrier
The DZ-1XX servo barrier gate series, which manufactured by our company, adopts international advanced technology, mechanical and electrical integrated design. Planet gear drive, high torque, un-blocked, oil tight, no noise, automatically Self-locked when power off, with 10 million operation times. The motor uses the DC 24V permanent magnet synchronous motor (PMSM motor), apply to the global voltage, high-speed operation and rapid response, frequent positive &negative operation in 24 hours does not heat, speed time can be adjusted based on the vehicle flow and arm length, safe and reliable. The series servo barrier gate is free-debugging and free-maintenance, achieve the fully automation and intelligent ,and the barrier arm open/close is fast and smooth, easy to use and safe.
Servo Motor Barrier Advantages:
|1. Gate automatically open when power off, no clutch design, no need human intervention. When power on, gate automatically reset, restore to the gate closing state, truly unattended, fire safety standards. If special requirement,manual operation is required when power off, operating arm open and close manually also can be realized by setting up control board DIP switch, which ensure that the system can be used at any time.|
|2. The use of Single Compression Balance Spring device, good regulation, no noise, indefatigable, not easy to break, safe and reliable.|
|3. A variety of input and output modes can be selected, normally open normally closed are optional.|
|4. Arm opening angle can be adjusted from 60 to 90 degrees, 10 degrees resolution, suitable for eaves prominent place to install.|
|5. Closing speed can be adjusted.|
|6. Barrier gate up &down signal relay switch output.|
|7. Barrier gate running state: OK signal output indicating that the gate is working properly.|
|8. Barrier gate operation abnormal alarm signal output.|
|9. R&G Traffic light relay switch signal output.|
|10. External loop detector signal anti-smashing interface, infrared sensor signal anti-smashing interface.|
|11. Count mode interface.|
|12. Arm Open priority anti-smashing function. No matter the current gate in what state, the operator through the triple push button, software or remote control to issue an open command, the gate will give priority to the implementation of the opening action.|
|13. Barrier with anti-collision protection function, when the vehicle hits the gate arm, arm can be swing out to avoid damage to the vehicle, and barrier gate machine.|
|14. Delay closed selection function.|
|15. High-sensitivity arm auto reverse function (intensity can be adjusted).|
|16. Parking system interface.|
|17.RS485 or RS232 network communication control up &down interface (no need to install communication module)|
|DZ-138 barrier gate||V06T||V09T|
|Max Boom Length and Diameter||2500mm, Ф75mm||3000mm, Ф75mm|
|Machine Case||Varnished 2.0mm steel plate||Varnished 2.0mm steel plate|
|Machine Case Size(W*D*H)||342*312*959mm||342*312*959mm|
|Operating Temperature Range℃||-45℃~+85℃||-45℃~+85℃|
|Driving Method||Servo motor||Servo motor|
|Remote Control Distance||≤100m (open, sunny weather)||≤100m (open, sunny weather)|
|Surface Treatment||Outdoor metal powder electrostatic spraying||Outdoor metal powder electrostatic spraying|
|Voltage(±10%)||100-240 volt||100-240 volt|
|Max Power Consumption(watt)||8||8|
|Control Voltage||24V DC/max.3000mA||24V DC/max.3000mA|
|Open Collector Output Number||2||2|
|Zero Level Reversal Relay Number||3||3|
|Operating Temperature Range℃||-45℃~+85℃||-45℃~+85℃|
|Barrier gate boom||1||Piece|
|Machine case press board||2||piece||For fixing case|
|Expansion bolt||M16X150||4||set||For fixing case|
|Supporting pole||1||piece||Optional part|
|Expansion bolt||M8||4||unit||For fixing boom|
|Boom fixed screws||M12*70||2||unit|
|Balance spring||1||unit||For spare usage|
A: Follow the steps on below to complete your order.
- 1. Inquiry
Provide us detailed information about your requirement, and we'll recommend the suitable products according to your request
Official quotation form with all clear specifications according to the order
Invoice will be issued once the quotation is confirmed.
Payment shall be issued once the invoice issued. Full payment is acquired.
Bulk production shall be taking 15-25 working days.
by sea, air or courier. Detailed picture of package will be provided upon the service you've chosen. Packaging info will be sent upon confirmation.
1. Two year’s free servicing is supplied (not including the arm and remote controller). In the condition of complying with the operating instruction, without the unauthorized maintenance of the parts and the machine have no obvious mechanical damage, we will provide a quality assurance for the barrier gate product from the date of use for a period of two years or from the date of shipment up to three years including all mechanical and electronic components other than special consumables.
2.Lifetime charged servicing is offered.
3.Technology servicing is supplied.
*The following situations are charged for servicing (or replacement):
1.Broken by wrong installation;
2.Broken by improper voltage;
3.The surfaces of the system destroyed by wrong installation or use.
4.Broken by natural disaster.
6.Servicing items out of the promises.
If you have any question, please contact us freely!
Sales representatives: Keira
Whatsapp: +86 18507481610
Contact Person: Keira Xia